Why are lithium-ion battery fires so dangerous on ships?

A lithium-ion battery failure aboard a ship can heat neighbouring cells and release gases that threaten the crew and may ignite. Enclosed spaces make exposure harder to control, and putting out visible flames may leave a battery at risk of reignition. At sea, the crew must manage those hazards with the detection, firefighting and protective arrangements already aboard.

What causes a lithium-ion battery to catch fire?

An internal failure or short circuit can cause a lithium-ion battery to release hot, flammable gases, according to a U.S. Coast Guard safety alert. The initiating fault need not be inside a cell. The same alert describes a fire in an installed battery bank on a passenger vessel after loosely crimped electrical lugs overheated.

Cargo has a different exposure: movement and physical damage. A Fire Protection Research Foundation presentation reports that rough seas disturbed battery cargo aboard Genius Star XI and contributed to damage preceding its fires. Installation inspection, cargo securing and early fault detection therefore address different starting points. None substitutes for the others.

What are thermal runaway and reignition, and why do they matter at sea?

Thermal runaway is an uncontrollable, self-heating state within a lithium-ion cell. The cell generates heat faster than it can shed it, potentially venting gas or electrolyte and producing smoke or fire, as UL Research Institutes explains. Heat can then affect adjacent cells and modules. Once fire spreads to other modules, the Coast Guard warns, suppression becomes very difficult.

Reignition is the post-fire problem. A battery that no longer shows flames may still contain heat and affected cells. For electric-vehicle traction batteries, IUMI recommends extended precautions after extinguishment because reignition risk is higher and lasts longer than for comparable internal-combustion-engine vehicle fires. An extinguished flame is not, by itself, an all-clear for access or vehicle handling.

See where Hydrogel fits your fire-safety strategy
From lithium-ion batteries to existing water-based suppression systems, speak with Anogas about your application.

Discuss your application

Why are lithium-ion battery fires so hard to stop on a ship?

Controlling the fire around a battery is different from stopping the self-heating within it. Shipboard systems can do useful work without doing both.

Measure What it can do Limit during thermal runaway
CO2 flooding Extinguish flames in a protected space It cannot stop thermal runaway.
Drenchers on RoRo and RoPax vessels Manage and control an electric-vehicle fire They do not stop the battery’s thermal runaway.
Water-based suppression Absorb heat and help contain the incident Cooling and containment remain necessary even when visible flames subside. The Coast Guard’s approach also depends on early detection.

A response plan therefore cannot be judged solely by whether an agent knocks down flames. It must also account for continued heat absorption, spread to other modules and the period after apparent extinguishment.

What toxic and flammable gases do battery fires release, and why does that endanger the crew?

A failing battery can vent a mixture that is both toxic and flammable. Its composition varies with battery chemistry and manufacturer. The Coast Guard warns that some emissions can exceed immediately dangerous exposure thresholds. Heat from a fire can increase gas release, while accumulated gas can ignite or explode. IUMI identifies hydrofluoric and other highly poisonous gases among the emissions, while cautioning that smoke from other vehicle fires can also be highly toxic.

Ventilation is therefore a crew-protection and ignition-control decision, not merely a way to clear smoke. EMSA recommends exhausting battery-space ventilation directly to open air, away from ignition sources and places where people could be exposed. Hydrogel is not designed to eliminate hazardous gas exposure. Ventilation, protective equipment and controlled entry remain necessary during any suppression response.

How do enclosed ship spaces and distance from shore make the danger worse?

An enclosed battery space can retain hazardous gas, but venting it can move the hazard elsewhere aboard. EMSA advises treating open-deck areas near off-gas outlets as hazardous and, preferably, locating outlets away from muster stations and lifesaving appliances. It also recommends planning post-fire battery-room entry on the assumption that the atmosphere may be toxic or explosive.

Anogas identifies confined spaces and limited evacuation options as particular maritime hazards. Outside help is also limited. IUMI recommends seeking professional marine firefighters or salvors when possible and briefing shore-based crews before they enter an unfamiliar vessel. Until that help is available, onboard detection, protection and response arrangements carry the load.

How did real incidents like the Genius Star XI and Felicity Ace unfold?

Genius Star XI carried 800 metric tonnes of lithium-ion batteries when fires occurred in two separate cargo holds. Its CO2 flooding system extinguished the first fire but used all the CO2 aboard. A second fire was reported in another hold days later, according to the Fire Protection Research Foundation. This was a separate cargo-hold fire, not evidence that the first hold reignited. It shows why the supply of extinguishing agent matters across a continuing incident.

Felicity Ace caught fire off the Azores while carrying more than 4,000 vehicles. All 22 crew members were saved after abandoning ship. The vessel burned for several days and sank. Investigators could not determine the exact ignition cause, although electric vehicles were thought to have intensified the fire, according to the same incident presentation. It should not be treated as a confirmed case of battery ignition.

What do regulations and guidance (IMO, USCG, ABS, AMSA, MCA) require or recommend?

Start by classifying what the batteries are doing aboard. For packaged dangerous goods, IMO explains that SOLAS chapter VII requires compliance with applicable IMDG Code provisions, including requirements concerning packing, stowage and segregation. Battery cargo and vehicles need carriage-specific assessment. An installed power system needs an installation-specific one.

For integrated propulsion or electrical-power battery systems on inspected vessels, the Coast Guard calls for engineering plan review, supporting safety systems, testing, inspection and competent maintenance regardless of bank size. For marine and offshore assets within its scope, ABS makes its requirements mandatory for installed lithium-ion systems rated at 20 kWh or greater, even without the optional ESS-LiBATTERY notation. Its document does not cover small portable devices such as laptops and power tools.

Guidance is not a single rule applying to every ship. EMSA describes its shipboard battery-energy-storage guidance as nonbinding good practice. AMSA publishes separate material for domestic vessel battery safety and battery-powered vehicle carriage. Operators should confirm which rules apply to their vessel and route rather than assuming that guidance for one installation or cargo type covers another.

How can the risk be reduced and the fire managed onboard?

A workable shipboard checklist links prevention to the response that follows a detected fault:

  • Detect and locate trouble early. For vehicle carriers and RoRo vessels, IUMI recommends addressable dual detectors and thermal-imaging cameras alongside suitable fire suits and breathing-air compressors.
  • Train for the vessel’s hazards. IUMI recommends vehicle-fire training for PCTC, RoRo and RoPax crews regardless of drivetrain. Crews need to know both the reach of their suppression systems and the limits of post-fire entry.
  • Provide suitable first-response means. For enclosed battery energy storage systems smaller than 50 kWh, EMSA recommends suitable lithium-ion battery fire suppression means for first responders. Its guidance also calls for arrangements that prevent hydrogen accumulation if water reaches batteries and causes electrolysis.
  • Assess an agent as part of the system. Hydrogel is a water-based agent containing modified natural clay. It cools hot surfaces, and its viscosity increases as temperature rises, which is intended to keep the agent in contact with them. It is used for battery rooms, onboard storage, cargo protection and mobile firefighting. Its effect depends on whether the agent can reach the battery, and an externally applied agent may not reach cells inside an enclosed pack. Verify the battery configuration, delivery arrangement and test evidence. Confirm compatibility with the vessel’s water-based system and approval requirements before relying on it, and do not assume an existing sprinkler system works with Hydrogel. Any change to mandatory marine fire protection needs engineering and approval checks.

Shipboard battery fire safety depends on controls working together

Battery cargo, electric vehicles and installed power systems have different starting hazards and different applicable requirements. Their common shipboard danger is that spreading self-heating, hazardous gas and residual heat can outlast visible flames while the crew has limited access to outside assistance. Detection, containment, cooling, ventilation, protective equipment and post-fire access procedures therefore have to work as one response, not as independent purchases.

For teams assessing Hydrogel in maritime applications, the practical next step is to verify its fit with the vessel’s existing water-based arrangement and the battery hazard it is intended to address.

Gerelateerde artikelen

Harry Verbakel